描述
物理参数
颜色： Iron red, medium grey
光泽： Matt/平
标准膜厚度：
湿薄膜厚度(WFT): 90 μm
干膜厚度(DFT): 35 μm
理论上传播率： Approx. 8.6 ㎡/kg
闪点： Non-flammable
密度： Approx. 1.32 g/cm³
应用程序的说明
混合比例： Single-component; ready for use after stirring thoroughly to a uniform consistency.
Pot Life (23°C): 2 hours (Note: Represents the open-container workable time once handled onsite.)
稀释剂: Deionized water
清洁剂： Tap water
应用的方法： 无空气喷洒，常规的空气喷洒，或者刷/罗涂层。
喷参数
| 参数 | 无气喷雾 | 常规的空中喷雾 | 刷/滚 |
| 喷嘴/尖端的尺寸 | (Graco) 163T-621/623 | 1.5 ~ 2.0 mm | — |
| 流体压力(MPa) | 12 ~ 25 | 0.3 ~ 0.5 | — |
| 疏比 | 0 ~ 5% | 5 ~ 10% | 5 ~ 10% |
Note: Airless and conventional air spray data are for reference only and can be adjusted based on onsite conditions during practical application.
干燥的时间和间隔复涂
| 基Temp. (°C) | Surface Dry (min) | 硬干(h) | 分。 复涂间间隔(h) | 最大。 复涂间间隔 |
| 5 | 120 | 24 | 12 | 没有限制 |
| 15 | 60 | 12 | 8 | 没有限制 |
| 20 | 40 | 8 | 6 | 没有限制 |
| 30 | 20 | 4 | 4 | 没有限制 |
表面准备
The steel substrate surface must be clean, dry, and completely free of oil stains, dust, mill scale, and loose rust. Cleanliness should reach at least Ah3 grade using power-tool cleaning.
When overcoating existing coatings, the old film must be abraded and roughened to eliminate chalked or loose paint layers. Clean thoroughly before primer application.
应用程序的条件
温度及湿度： The application temperature range is 5 ~ 40°C with a relative humidity (RH) below 80%. The substrate surface temperature must be at least 3°C above the dew point.
制约因素： Humidity levels must not be excessively high, as high-humidity environments easily induce flash rusting. Outdoor application is strictly prohibited during rain, snow, heavy fog, or severe wind and sandstorms.
Sub-Zero Warning: The application ambient temperature must never fall below 0°C. Low temperatures will cause latex emulsion breakage (phase separation), rendering the coating ruined and unusable.
涂层系统的兼容性
Subsequent Coats (Topcoats): Waterborne Alkyd Topcoat, Waterborne Acrylic Topcoat, or standard solvent-borne Alkyd Topcoat.
包装的规格
20公斤/桶
储存
Store this product in a cool, dry, and well-ventilated indoor warehouse. Ensure protection against freezing.
The storage temperature range must be maintained between 5°C and 30°C. The shelf life is 一年 under standard temperature conditions.
安全预防措施
This product is a waterborne coating and is non-flammable. Maintain good ventilation throughout the application site.
Applicators must wear appropriate personal protective equipment (PPE) to prevent inhalation of paint mist and avoid contact with eyes or skin.
If paint contacts the skin, wash immediately with fresh water and soap. If it splashes accidentally into the eyes, rinse continuously with a large volume of water and seek immediate medical attention.
免责声明
保护性能的任何涂层在很大程度上取决于应用程序因素。 表面准备和薄膜厚度将会直接影响到服务的生活的涂层。 用户必须确保遵守规定的应用条件。
提供的数据，在这本手册是理论上的价值或来源于实验的积累。 一些数据可以改变由于持续的产品的改进，无须事先通知。
当我们的公司的技术人员都是不存在的应用程序的网站，该公司承担全部责任的质量的涂料产品本身。
